|
 |
 |
| ... and some electrical tape to avoid short ciruits. |
|
 |
| Carefully thread the cable beneath the circuit board with the main power switch. |
|
 |
| Now solder the wires to the corresponding pins of the XBee-Module ... |
|
 |
| ... and secure everything with electrical tape. |
|
 |
| Unplug the main power cable, store the XBee module behind and replug the connector. |
|
 |
| Put the white plastic coverage back in front of the power cable and screw together Pleo. |
|
 |
| If you now connect the second XBee-Module with serial board od the XBee Developement Starter Kit you can open the COM1-port to communicate with Pleo. Very well does this work with the excellent Dino-MITE-Software. |
|
|
